BIOS Parameters
Cylinders Heads Sectors per Track
M1603TAU 1055 16 63
M1606TAU 2111 16 63
ORIENTATION
The drive may be installed in one of three orientations; either PCA down or on either edge. Inclination from vertical or horizontal should not exceed 5°.
MOUNTING SCREW FIXING
When the mounting screw holes on the side of the drive are used, then use only the two pairs of outer holes. Do not use the centre holes in conjunction with only one of the outer holes. Drives with the suffix TAM accept M3 screws while drives with the suffix TAU accept #632UNC screws. The screw must not penetrate the drive by more than 4 millimetres
GROUNDING
Sufficient grounding will be provided for correct operation when the drive is screwed into an electrically grounded frame.
COOLING
Allow space above and below the drive to provide for adequate air flow. Fan cooling is recommended. The disk enclosure temperature, measured at top centre, should never exceed 60°C.