| Installation 
The DL700 is a Centronics interfaced printer,
there is no serial interface option available. Pin 18
does not provide any power for external
devices.
Switch & Jumper Settings
The DL700 has no dip switches or jumper settings.
Use the supplied DLMENU program to change printer
configuration. This file is available in the Printer
section of the File Library
On non PC systems or when DLMENU is not available
holding down the LOAD & ONLINE buttons during
power up will put the printer into off-line set up
mode, the printer will print out further instructions
describing operation in this mode.
|
