• Do not install the device in a place where excessive vibration may occur.
• Keep the scanner out of direct sunlight and away from any heat sources.
• Do not place any material around the scanner to ensure adequate air circulation.
• Do not install the scanner in a humid or dusty environment.
• Do not connect the scanner to a wall socket that services any other noisy devices, such as electric motors.

Diagnostics

The ScanPartner 10 has diagnostics to help determine the cause of some operational problems. Some of the diagnostics function with the scanner online, while others are part of a separate offline diagnostics feature.

Online Diagnostics.
Determine operational problems by observing the control panel Ready and Paper Jam LEDs. With the scanner online and operating normally, the Ready LED is on and the Paper Jam LED is off. Any other LED combination indicates a problem.

Ready LED	Paper Jam LED	Error Indication
ON	ON	Group 3 error
OFF	Blinking	ADF cover open
Blinking	OFF	Group 1 error
Blinking	Blinking	Run offline diagnostics

Switch Settings

There is only one one switch that needs to be configured before the scanner is connected to the SCSI bus. The SCSI ID selection switch, located at the back of the scanner close to the interface connector, must be changed to a unique number. Normally the host would take ID 7 with peripheral devices taking IDs 0 through 6 although convention requires that the scanner appears at ID 5. Check the SCSI host documentation for further details.

Selected Spare Parts

ADF Subassembly	002-0001-0
Motor Module	002-0002-0
Optical Subassembly	002-0002-0
Power Supply	003-0001-0
Hinge Unit (Left)	003-0015-0
Hinge Unit (Right)	003-0016-0
Main Board (MB02 PCA)	004-0009-0
ADF Cover	051-0004-0
Shipping Retainer	055-0001-0
Daisy Chain SCSI Connector	103-2527-0
Terminator (SCSI)	103-2528-0